Manufacturing

DISCUSSION OF PRODUCT DESIGN The two design features for our encounter were the rack introduction holders and vehicle body cavity. When manufacturing the wheel base holders, we do a 0.5 diameter incinerate into a .7x.7 composing of pol to that extenthylene. This was to prevail the axle and wheel assembly. The goal was to hold it tightly enough, yet quit enough valuation reserve to have it be taken glum by the robot efficiently. Next, the machine domiciliate was an 8.00 in. long, by 2.00 in. tolerant by 1 in. thick disaster. The box had a cold shoulder out cavity ratio of 1 in wide, 0.5 deep, and 7.5 in long. We chose this dimension because it properly held two cars, with an prehend amount of tolerance so that they could be easily removed. The breadth of the box provided a disclose seat for the vehicles by having them part sit on top of the box, and their bottom half intimate of the cavity. The major social occasion that we would change with our desig n is the tolerances. surrounded by are two move that held the axles and cars, we would reduce the tolerances by 0.03 with axels and 0.03 with the car holder. Furthermore, we would improve the finishes. This would provide better and more consistent picture for the axles and cars. INSPECTION Along with comparing our harvesting with the original dimension drawing, we used digital calipers to measure the dimensions of our work. after(prenominal) that, we obtained some(prenominal) axle and car assemblies from the other groups and tested how well they fit into our holders. After we manufactured our part, we undercoat that we were in truth close and inanimate on in some cases, with our parts. We found that there were some inconsistencies in the axel nutritions, in which the diameter of the cut fluctuated roughly .03-.07 mangle of the sought after dimension. We got 50 .43, .47, and .50. Our car support box was conciliate and the cavity fell within the d esired tolerances of +-.03 with dimensions o! f 2.01, 8.00, and 1.01. COST To manufacture our part, we had a combined process snip of 40 minutes as seen in...If you want to get a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper